To Print this page right click here and choose print from the list of options
Technical Details
For Emergency Control Gear and remote Emergency Systems

  • Most modules and PCB's are tested and approved to EN60924/EN60925. They are EMC compliant to EN55015 and carry the British Standard Kitemark and CE mark.

  • They incorporate over temperature and charger short circuit protection.

  • Mains supply 230V - 6% + 10% 50/60 Hz power consumption 8VA (Other supply voltages available on request)

  • Output circuitry uses a high efficiency sinusoidal inverter, with nominal operating current of 1 Amp

  • Available as standard in 3 hour operation (other durations to order)

  • All modules have battery over discharge protection as standard (DDP) to prevent discharge below 1 volt per cell

  • Reverse battery polarity protected o All connections are via terminal blocks with a red light emitting diode, (LED) to indicate correct charging conditions

  • Operating temperature range Module 0 to 70°C (centre side of case)

  • Printed Circuit Boards 0 to 90°C (coil/core of charging transformer)

Module Dimension (millimetres)
 
Remote Box Dimensions (millimetres)
   
Printed Circuit Boards Dimensions (millimetres)